LETTER TO JOE FROM (Sanitized)
Document Type:
Collection:
Document Number (FOIA) /ESDN (CREST):
CIA-RDP66B00728R000100120022-2
Release Decision:
RIPPUB
Original Classification:
S
Document Page Count:
3
Document Creation Date:
December 12, 2016
Document Release Date:
March 14, 2002
Sequence Number:
22
Case Number:
Publication Date:
May 10, 1963
Content Type:
LETTER
File:
Attachment | Size |
---|---|
![]() | 134.17 KB |
Body:
Approved For Release 2002/08FCR ff-RDP66B00728R0001 0 0-
COPY / OF
AM-735
May 10, 1963
P. 0. Box 2605
Buffalo 26, New York
In my letter of May 3rd I omitted sending the description
f the Area Ready Rework - two (2) copies of same are enclosed.
Enclosed is our cost proposal on the Area Van Spares.
cost proposal was requested several months back by
25X1A
25X1A
as we discussed at your office during our meeting of April 17th.
I will discuss this with next week.
The estimating figures are vailable for is analysis
at any time. ( CA/M e4 1, +.
I have completed the scope definition of the contract
25X1A Also, I have revised,slightly, the cost breakdown document.
I hope it simplifies your analysis. We will start the added
scope definition on new problem investigation areas we have
worked on and are pursuing as of the fiscal year with estimates
for completion of the total EC-8250 Contract. However, I feel
that you are more interested in finalizing the outstanding
document. To my knowledge, we will be ready to discuss finali-
zation within the next few weeks.
25X1A visited Pioneer on May 1st.
5X1A agrees that we should have the contract up-dated. His
Accounting Department is now preparing cost data; his engineers
and estimators are generating information for cost to complete the
contract. We should have this problem resolved by June 1st and
all information available at this time so that we may firm our
cost to complete our parachute phase of the program.
To-date we have sent you only the cost proposals and 25X1A
descriptions of the Service Vans requested by
At the same meeting he requested our recommendations anc cost
on ready room equipment and field service kits to support the
DOCUMENT NO.
NO CHANGE IN CLASS.
p DECLASSIFIED
CLASS. CHANGED TO TS S 0
NEXT REVIEW DATE]
RUTH: 191 70. n
DATE. 3 y 9991 REVIEWUL 064540
Approved For Release 2002jfCj)ETA-RDP66B00728R000100120022-2
.. Approved For Release 2002/06x112 CIA-RDP66B00728R000100120022-2
25X1A
AM-735
May 10, 1963
problem as he then knew it. We expect to have these two 1(2)
proposals and descriptions to you within ten days.
As mentioned earlier this week in our telephone conversation,
25X1A we are concerned about required delivery for his
service vans. The principle problem is the lead time for the
25X1A basic vans. Our vendor is not flexible enough to allow us to
meet delivery date (October) if we delay longer
than a week to ten (10) days in placing the order for the
basic vans.
Toda we ordered six (6) Rate Gyros at the request of
They are for the Ejection Tests to be run in
June at El Centro. I was told that Harry had consulted with
you on this procurement and you advised him to have us place
the order. See copy of order-TWX-enclosed)
We would appreciate you advising us as soon as you have a
decision on the vans.
Very truly yours,
25X1A
Enclosures: Spares Parts List (2)
Description Area Ready Rework .(2)
TWX - Order to Humphrey Inc.
Approved For Release 2002/06/11 : CIA-RDP66B00728R000100120022-2
Approved For Release 2002/06/11 : CIA-RDP661300728?0601012 3 1
SPARE PARTS LIST
DN 704 00-1 - MAINTENANCE VAN
REPAIR KITS
PRINCIPLE ITEMS LISTED
DN 720-60-1
Vacuum Pump Kit
$ 252."65
DN 720-61-1
V-Belt, Shaft Seals,
Gaskets, etc.
Altitude Chamber Kit
148.01
/o
DN 720-62-1
Door Gasket, Motor
Starter Parts
Air Conditioner Kit
586.05
Condensor Fan Motor,
Suction Valve Kit,
Solenoid Valve, Expansion Valve
DN 720-63-1
Vacuum Pump Cooler Kit
188.58
DN 720-64-1
Pressure Control,
Impeller, Expansion Valve
Thermostat and Solenoid
Vent Air Cooler. Kit
180.37
DN 720-65-1
Circulating Pump,
Expansion Valve, Carbon
Seals and Thermostat
Test Stand Kit
1,741.30
24 - Manometers, Absolute & Gage Type
4 - Flowmeters
5 - Control Valves
2 - Gages
Hose Assemblies & Gaskets
3,o96.96
Approved For Release 2002/06/11 : CIA-RDP66B00728R000100120022-2