PROPOSED PROGRAM

• Document Type: CREST
• Collection: NGA Records (Formerly NIMA)
• Document Number (FOIA) /ESDN (CREST): CIA-RDP78B04747A001100020042-2
• Release Decision: RIPPUB
• Original Classification: K
• Document Page Count: 2
• Document Creation Date: December 28, 2016
• Document Release Date: December 2, 2004
• Sequence Number: 42
• Content Type: REQ

Approved For Release 2005/02/10 : CIA-RDP78B04A001100020042-2
o .,
The following is the suggested modification to the proposal,
"Mic odensitometer Support" submitted by Changes
to Saction 3 will also result from these modifications, but the proposed
contractor can redetermine that section.
SECTION 2
PROPOSED PROGRAM
The program will be carried out in two Phases with four Sub-phases
under Phase II. Generally speaking, Phase I comprises a familiarization,
-test, training and calibration period whereas Phase II includes specific
applications in several areas.
STATI
This Phase of the program will consist of the-necessary familiarization
with equipment, on-site and in-plant training, and equipment validation.
These procedures will be largely of a calibration and diagnostic nature.
It is proposed that the following be included in Phase I:
1. Basic Operator training at the contractor's plant, consisting
of a two-week period for two operators.
2. Equipment Familiarization and test at cus{tomer's facility and
STATINTL at This step will include test runs,
diagnostic measurements, overarm stability tests, etc., with
data to be gathered on site and reduced at the Icontractor's
plant. A test report will be issued.
Phase II will include the provision of solutions and procedures
which are specifically. oriented toward operational problems. This
Phase will include four Sub-phases, defined below:
1. Sub-phase A
This step will consist of the establishment of detailed
calibration, mensuration, and diagnostic procedures, suitably
defined and published. Operator aids in the form of nomography,
charts, etc., will be provided. Basic color techniques will
be devised, with particular emphasis on balance and aperture
size for various materials. Training will be provided where
required. Standard practice handbooks, forms design, logging
recommendations, and recommendations for quality control and
maintenance programs will also be provided.
Declass Review by NGA/DOD
HTL
Approved For Release 2005/02/10 : CIA-RDP78B04747A001100020042-2
 Approved For Release 2005/02/10 : CIA-RDP78B04 7P 001100020042-2
Procedures requiring computer treatment will be defined
to the point where programming could begin and test data for
computer program analysis will be generated.
2. Sub-phase B
This Sub-phase will include the generation of reports
giving detailed procedural information for programming
the following.
a. Modulation transfer function (MTF) generation, utilizing
estimating filter techniques.
b. A general "one-shot". MTF technique.
c. Noise study procedures, including statistical analysis,
auto-correlation analysis, power spectral density computation,
etc., including trend correction, window selection, and
other techniques designed to improve confidence in results.
A running auto-correlation procedure and. a piece-wise
p,s.d. estimator will be provided also.
d.~ Table generation and data conversion procedures for
effective exposure and generation synthesis. i
e. Comparison techniques, including mean square difference,
cross-correlation, and other methods.
f. Mensuration data handling procedures.
3.
Sub-phase C
This Sub-phase will be devoted to the prekaration of
problem solutions and procedural recommendations specifically
related to the exploitation aspects of microde .sitometry and
to the problems of a system diagnostic nature. Training will
be included as required and reports will be generated giving
step by step procedures for diagnosing exploitation system
anomolies. Procedures for determining confide ce factors in
the diagnosis will also be established. Appli ation of the
microdensitometer to display techniques includ ng density
contouring will be considered, with particular emphasis on
the detailed study of small scale objects.
4. Sub-phase D
This Sub-phase will consist of investigations into color
microdensitometry. Detailed procedures for tr.-color operations
will be published. Advanced studies of color Iicrodensitometry
will be conducted with emphasis on computerize data treatment.
Training will be provided as required. '
Approved For Release 2005/02/10 : CIA-RDP78BO4747AO01100020042-2