MICROSCOPE CARRIAGE INSTALLATION

• Document Type: CREST
• Collection: NGA Records (Formerly NIMA)
• Document Number (FOIA) /ESDN (CREST): CIA-RDP78B04747A001400040005-8
• Release Decision: RIFPUB
• Original Classification: K
• Document Page Count: 1
• Document Creation Date: December 28, 2016
• Document Release Date: February 8, 2002
• Sequence Number: 5
• Content Type: NOTES

Approved For Re se 2002/06/17 : CIA-RDP78B04747A0011400040005-8
*We
MICROSCOPE CARRIAGE INSTALLATION
CAUTION:
Micro switch actuator at rear of table in rail housing must be
depressed when putting the microscope carriage on the rails.
If the switch actuator is not depressed it will be badly "mutilated.
1. Remove stops from left ends of rails.
2. Orient microscope carriage so that front of light table and front of
microscope carriage correspond.
3. Slide microscope carriage on rails from left end of table.
4. Install stops removed in Step 1.
5. Slide film hold down glass between microscope carriage and film viewing
surface such that the hinge on the glass is at the rear of the microscope
carriage. Install clip and adjusting chain on front of film hold down glass.
haWdle
6. Install brakenon front of microscope carriage.
Declass Review by NIMA / DoD
Approved For Release 2002/06/17 : CIA-RDP78B04747A001400040005-8